OE No. : NCV36568=1;NCV36569=1
Position: Front
Fitment: Replacement for Honda Civic Auto Trans 1.8L I4 06-11 w/AT
OE quality: ISO/TS16949 certified, tested to the strictest OE standards, also improved those traditional design weaknesses, to ensure vehicle fitment and product reliability.Easy Installation: Brand-New; arrives fully assembled; threads&splines are precision rolled for hassle-free direct replacement.
Warranty: A year warranty. If it does not fit your vehicle, we accept return. Please make the item clean and package in good condition.
WHAT IS a CV Axle
CV (constant-velocity) axles, (also known as half-shafts), are used in front-wheel drive vehicles to transfer the engines power from the transaxle to the two drive wheels. Some late model vehicles with independent rear suspension and some four-wheel and all-wheel drive vehicles also use CV axles.

A CV axle has two CV joints (an inner joint and an outer joint). These joints allow the axle to transfer the engine’s power to the drive wheels at a constant speed while accommodating for the different travel conditions, including the up and down motion of the suspension and cornering. Without constant-velocity joints, the axles would bind or break whenever the vehicle hit a bump in the road or turned a corner.

How-to steps for replacing two CV joint axles
STEP 1

STEP 2

STEP 3

STEP 1
This is a rear drive vehicle with two CV joint axles. Start by disconnecting the battery, jacking up the vehicle and allowing some penetrating oil to soak into any retaining bolts.

STEP 2
In this case, suspension disassembly was not required. Moving brake lines and other obstacles out of the way of wrenches is a good bet before beginning.

STEP 3
Loosening but not removing the strut top mounts and sway bar end link bushings can provide a bit more suspension travel for easier axle removal.

STEP 4

STEP 5

STEP 6

STEP 4
Loosen and remove the wheel side axle mounting bolts.

STEP 5
Separate the axle from the wheel. Do not allow the axle to hang from the transmission or differential. Oil seals could be damaged.

STEP 6
Gently pull, pry or otherwise liberate the axle from the transmission or differential. Do not bend axle seals. Be careful not to tear the transmission or differential oil seals.

STEP 7

STEP 8

STETP 9

STEP 7
Don’t forget to transfer any axle seals, ABS rings or other parts to the replacement axles.

STEP 8
Guide the replacement CV joint axle into place. Depending on the type of retainer, the axle should click firmly in place.

STEP 9
Always use the proper torque on the axle bolts. Check axle rotation. Reassemble dismantled components.